Secret Project #16638

20121009-141501.jpg

Ever since I found you could get little SMD jumpers (zero ohm resistors) it’s made laying complicated circuits on single-sided circuit boards much easier. Normally if you need a signal to cross over other tracks without touching them, you have to solder little wire jumpers in to form bridges, which means a lot of careful wire measuring and stripping (you can see the red ones above). For little jumps I can use the SMD resistors – the little black oblongs with 000 printed on them. If you’re careful they can jump over 3 other tracks…

2 thoughts on “Secret Project #16638

  1. Hi,
    can you name a source for this type of jumper “resistors”?
    They are really handy, but i can’t find any supplier..

    Thanks in forward und greetings from Germany
    Jan

    1. RS, Digikey, Farnell, Mouser etc all seem to do them. They’re just treated like any other resistor – just find a range of SMD ones you like and somewhere on the list of values there’ll probably be a 0 ohms one…

Leave a Reply

Your email address will not be published. Required fields are marked *

Anti Robot Device *